Bosch DS7200V2-EXP Guia do Utilizador descarregar pdf (Página 95)

DS7200V2-EXP | Expert Programming Guide | 4. Control Panel Programming EN | 95

Bosch Security Systems | 8/04 | 4998153891C

Table 22: Off-board Zone Pulse Count Time Selections

Pulse Count Time for Off-board Zones

Selection Pulse Count Time Selection Pulse Count Time

0 10 sec 8 20 sec

1 20 second 9 30 sec

2 40 sec 10 40 sec

3 60 sec 11 50 sec

4 80 sec 12 60 sec

5 100 sec 13 90 sec

6 200 sec 14 120 sec

7 300 sec 15 200 sec

Pulse Count/Pulse Count Time Example:

Follow these steps to program a zone function to detect four 60 ms pulses within 10

sec before it declares the zone

off-normal:

1. Enter “4” in the Pulse Count address of the Zone Function you are configuring. “4” identifies the number of

pulses the control panel must receive.

2. Since your time span is 10

sec, this zone function uses a zone scan time of 60 ms and is only for on-board

zones (see left side of Table 21). The selection for 10

sec is 6. Enter “6” into the Pulse Count Time address of

the Zone Function you are configuring.

When using the 24-Hour Door Zone Function Type, Pulse Count Time determines how long the zone

must be faulted when the area is disarmed before creating an alarm on the zone (range of 0.5 to 300

sec).

Options 1, Zone Function ##

Options 1 for Zone Function Types 0 to 2, 5 to 8, 11 to 15

• Address: See Table 17 on page 88

• Default: See Table 17 on page 88

• Selections: 0 to 15

Enter This Data Digit to Select Options

Options 1, Zone Function 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

No Options Enabled

•

Enable Alarm Event Abort

• • • • • • • •

Voice Verification

• • • • • • • •

Armed for Perimeter Only Mode

• • • • • • • •

Sensor Trouble Monitor

• • • • • • • •

The option chart above applies to all zone function types except the following:

• Zone Function Type 3 (24-hr Control Input)

• Zone Function Type 4 (24-hr Tamper)

• Zone Function Type 10 (Controlled Keyswitch)

The following sub-sections explain how to program the zone function types listed above.

Zone Function Type 9 is reserved and cannot be programmed.

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 155 156

Comentários a estes Manuais

Sem comentários

Bosch DS7200V2-EXP Guia do Utilizador Página 95

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Bosch DS7200V2-EXP