Bosch DS7200V2-EXP Guia do Utilizador descarregar pdf (Página 103)

DS7200V2-EXP | Expert Programming Guide | 4. Control Panel Programming EN | 103

Bosch Security Systems | 8/04 | 4998153891C

4.5.3 Global Zone Configuration

On-board Location EOL Resistor Value

• Address: 1026

• Default: 5 (Tamper-wired loops, single tamper-wired sensors)

• Selections:

− 0 = No EOL Resistor

− 1 = 1 k EOL Resistor

− 2 = 2.2 k EOL Resistor

− 3 = 3.65 k EOL Resistor

− 4 = Zone Doubled, 2.2 k & 3.65 k EOL Resistors

− 5 = Tamper-wired loops, single tamper-wired sensors

− 6 = Tamper-wired loops, multiple tamper-wired sensors (up to 5 max)

This parameter applies to the control panel’s eight on-board sensor loops.

If zone doubling is turned on, the locations are paired as shown in Table 23.

Table 23: EOL Resistor Location Pairing for Zone

Doubling

Location (Sensor Loop)

EOL Resistor 1 2 3 4 5 6 7 8

3.65 k 1 2 3 4 5 6 7 8

2.2 k 9 10 11 12 13 14 15 16

Zone Response Options (for all zones)

• Address: 1027

• Default: 0

• Selections: 0 to 3

Enter This Data Digit to Select Options

Zone Response Options 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

No Options Selected

•

Enable Smart Swinger

• •

Unverified Events Send Trouble Reports

• •

Reserved

• Smart Swinger: If enabled, this option allows zones that were Swinger Shunted to report new alarm events if

they are faulted when Bell Time is running. The ARC receives alarm reports from zones that previously

reported as Swinger Shunted. When Bell Time is running, the Swinger Count applies to these zones. They

only send reports until Bell Time expires or until the swinger count is reached again at which time they

Swinger Shunt again. If these bypassed zones are faulted when Bell Time is not running, they remain Swinger

Shunted and do not send reports.

• Unverified Events Send Trouble Reports: If this option is enabled, Fire Alarm with Verification zones that

have single, unverified events generate an Unverified Event report. Zones with the Cross Zone option enabled

that have a single pulse generate an Unverified Event report.

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 155 156

Comentários a estes Manuais

Sem comentários

Bosch DS7200V2-EXP Guia do Utilizador Página 103

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Bosch DS7200V2-EXP