Bosch DS7200V2-EXP Guia do Utilizador descarregar pdf (Página 29)

DS7200V2-EXP | Expert Programming Guide | 4. Control Panel Programming EN | 29

Bosch Security Systems | 8/04 | 4998153891C

• Test Battery: If enabled, this option makes the “battery test” part of the system test. The battery test causes

the system to run on battery power only for four min. If the battery voltage falls below 12.1 V during the four-

min. test, or if the battery is missing, the system restores AC power and displays a system trouble at all

keypads. If programmed for battery reports, the control panel sends a low battery or missing battery report.

Press [#] to end the test.

• Send Test Report: If enabled, this option makes a “communications test” part of the system test. If selected,

this option causes the control panel to attempt to send a Test {137} report when the user initiates a System

Test ([#][4][1]). If there is a system trouble present at the time of the test, the control panel sends a Test, Off

Normal {138} report. The test report follows the routing for Test Report Routing (Address 0255). If the test

communication is unsuccessful, the control panel creates a system trouble communication failure.

System Test Enable Options

• Address: 0245

• Default:

− DS7240V2: 15

− DS7220V2: 3

• Selections: 0 to 15

Enter This Data Digit to Select Options

System Test Enable Options 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

System Test Disabled

•

Enable System Test for Area 1

• • • • • • • •

Enable System Test for Area 2

• • • • • • • •

Enable System Test for Area 3 (DS7240V2 only)

• • • • • • • •

Enable System Test for Area 4 (DS7240V2 only)

• • • • • • • • •

This option enables the System Test function ([#][4][1]) for each of the areas. Although the configuration of

System Test is global, the function is only enabled for keypads in the areas selected here, and only for users with

the proper authority level. See Authority Level Option 9: System Functions 1 on page 57 for more information.

If the System Test is not enabled in the previous parameter (Address 0244 is set to Data Digit 0), then

this parameter is not functional and does not need to be programmed.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 155 156

Sem comentários

Bosch DS7200V2-EXP Guia do Utilizador Página 29