Bosch DS7200V2-EXP Guia do Utilizador Página 129

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 156
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 128
DS7200V2-EXP | Expert Programming Guide | 4. Control Panel Programming EN | 129
Bosch Security Systems | 8/04 | 4998153891C
4.10 Network Communication
Firmware revision 2.10 or greater is required for network communication.
The control panel can be configured to communicate over an Ethernet network. Reports can be sent over this
network from the control panel to the ARC receiver. Remote programming can also be conducted over this
network. A DX4020 Network Interface Module (NIM) is required for network communication. See “Network
Interface Module (DX4020)” in the DS7200V2 Installer’s Guide (P/N: 4998153893) for installation/configuration
instructions.
Use the following steps to configure the control panel for network communication:
1. Enter an IP address for the ARC receiver [refer to IP Address 1 (2) for Destination 1 (2)].
2. If necessary, enter a port number for the ARC receiver’s IP address (refer to page 130).
3. Set the Alternate Communication Options parameter to “5” (refer to page 132).
4. Set the Network Interface Module Options parameter to “3” (refer to page 135).
IP Address 1 (2) for Destination 1 (2)
Address:
IP Address 1, Destination 1: 0000 to 0031
IP Address 2, Destination 1: 0032 to 0063
IP Address 1, Destination 2: 0066 to 0097
IP Address 2, Destination 2: 0098 to 0129
Default: All zeroes (0)
Selections: 000.000.000.000 to 255.255.255.255
Each routing destination can be configured as a phone number or an IP address for network communication.
When entering an IP address, only the first 12 digits are used. For example, to enter an IP address of 172.30.1.101
into the Phone 1, Destination 1 addresses, enter the following digits in the first 12 addresses: 1, 7, 2, 0, 3, 0, 0, 0, 1,
1, 0, 1.
See Table 30 for entry selections.
Table 30: IP Address Entry Selections
Digit Enter at Keypad Digit Enter at Keypad
1 [1] 6 [6]
2 [2] 7 [7]
3 [3] 8 [8]
4 [4] 9 [9]
5 [5] 0 [0] or [1][0]
Vista de página 128
1 2 ... 124 125 126 127 128 129 130 131 132 133 134 ... 155 156

Comentários a estes Manuais

Sem comentários