Bosch DS7200V2-EXP Guia do Utilizador descarregar pdf (Página 104)

DS7200V2-EXP | Expert Programming Guide | 4. Control Panel Programming EN | 104

Bosch Security Systems | 8/04 | 4998153891C

Bypass/Force Arm Report Routing

• Address: 1028

• Default: 1 (Reports to Destination 1, Events to Log/Printer)

• Selections:

− 0 = No Reports, no Events to Log/Printer

− 1 = Reports to Destination 1, Events to Log/Printer

− 2 = Reports to Destination 2, Events to Log/Printer

− 3 = Reports to Destinations 1 & 2, Events to Log/Printer

− 4 = Reports to Destination 2 only on Destination 1 Comm Fail Event, Events to Log/Printer

− 5 = No reports, Events to Log/Printer

This parameter sets the routing for Bypass and Forced reports. See “Communication Failure (Comm Fail)” for a

description of the Comm Fail event and “Dialing Attempt Tables” for dialing sequence in the DS7200V2 Installer’s

Guide (P/N: 4998153893).

Enable reporting at the Global Reporting Options parameter (see Global Reporting Options on page

19), and enter at least one phone number (or IP address) for one routing destination (see Phone

Number 1 (2) for Destination 1 (2) on page 9).

Swinger Count for Alarm Output

• Address: 1029

• Default: 3

• Selections:

− 0 (Swinger disabled)

− 1 to 15

Each individual zone has a swinger count for alarm output.

Swinger Shunt reports are not sent for Swinger Shunt for Alarm Output. Zone reports have their own swinger

count (see Swinger Count for Zone Reports on page 105). The Swinger Count is reset on both arming and disarming

of the system, allowing Swinger Shunt to work for both non-24-hour and 24-hour zones. A trouble condition

occurs after Swinger Shunt.

Example: Assume the Swinger Shunt option is enabled, the control panel is armed, no zones are in alarm and the

Swinger Count for Alarm Output is set to 2. Zones 1, 3 and 5 go into alarm. At the end of Bell Time, the Swinger

Count for Alarm Output for Zones 1,3 and 5 decrements from 2 to 1. Since the counter does not reach zero, no

zones are bypassed. A second alarm event for any of those zones bypasses that zone.

When the Swinger Count is set to zero (0), Swinger Count for Alarm Outputs is disabled. The alarm

outputs activate on every new alarm.

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 155 156

Sem comentários

Bosch DS7200V2-EXP Guia do Utilizador Página 104