Bosch PIN8 N1 Guia de Resolução de Problemas descarregar pdf (Página 664)

100

101

10-82 Handling, Diagnostic and Service Functions MPH-02, MPB-02, MPD-02

DOK-INDRV*-MP*-02VRS**-FK01-EN-P

Write Access to a Parameter

As a basic principle, write access to a parameter is carried out as follows:

IDN of the parameter, data block element number, w, operating data

(Carriage Return)

After the writing operation the drive responds with its prompt again.

In order to access the parameter value of the P-0-4073 parameter, for

example, the following input is required:

Step 1

Send request e.g.:

"P-0-4037,7,w,1000" (CR)

Step 2

Drive received character.

Drive repeats request (echo)

Character sequence ":>" found in

receiver buffer?

Compare ok? Transmission error

Step 4

Delete request in receiver buffer.

All characters to 1st "CR"

(inclusive).

Step 3

To check transmission compare request

with receiver buffer (string compare).

yes

Next character "#" in

receiver buffer?

Parameter succesfully written

yes

Contents of receiver buffer:

"P-0-4037,7,w,1000" (CR)

[#xxxx (CR)] "E01:>"

Error occurred during

parameter access.

Error code: #xxxx

Communication with drive not

possible

-> check address

-> check setting

-> check connection

Timeout ?

yes

FD5001B1.WMF

Fig. 10-42: Write access to a parameter

Note: The entered data must correspond to the data type defined in

the attribute (HEX, BIN or DEC).

See also chapter "Error Messages in the Case of Serial Communication"

1 2 ... 659 660 661 662 663 664 665 666 667 668 669 ... 727 728

Comentários a estes Manuais

Sem comentários

Bosch PIN8 N1 Guia de Resolução de Problemas Página 664

Comentários a estes Manuais

Manuais e produtos relacionados com Fogões Bosch PIN8 N1