Bosch PIN8 N1 Guia de Resolução de Problemas descarregar pdf (Página 593)

100

101

MPH-02, MPB-02, MPD-02 Handling, Diagnostic and Service Functions 10-11

DOK-INDRV*-MP*-02VRS**-FK01-EN-P

Respective diagnostic command message:

• C0400 Switching to parameter mode

Respective diagnostic messages in the case of possible command errors:

• C0402 Only allowed without master

Note: The drive returns to the operating mode by a successive start

of the commands S-0-0127, C0100 Communication phase 3

transition check and S-0-0128, C0200 Communication

phase 4 transition check!

When reading and writing individual parameters via the control master or

DriveTop (without command), the following error messages can possibly

occur:

• F2100 Flash defective

• F2101 It was impossible to address MMC

• F2102 It was impossible to address I2C memory

• F2103 It was impossible to address EnDat memory

IDN Lists of Parameters

Some of the parameters stored in the drive contain, as their operating

data (parameter value), a list of IDNs of drive parameters. These so-

called IDN lists enable the master or a commissioning software to handle

drive parameters in a specific way.

S-0-0017, IDN-list of all operation data

The parameter S-0-0017, IDN-list of all operation data contains the

IDNs of all parameters available in the drive.

S-0-0192, IDN-list of backup operation data

The parameter S-0-0192, IDN-list of backup operation data contains

the IDNs of all parameters that are stored in the non-volatile memory

[MultiMediaCard (MMC) or flash memory]. These parameters are required

for correct operation of the drive. With the master or a commissioning

software it is possible to use this IDN list for making a backup copy of the

drive parameters.

S-0-0021, IDN list of invalid operating data for

communication phase 2

In parameter S-0-0021, IDN list of invalid operating data for

communication phase 2 the IDNs of those parameters are automatically

entered that the drive software detects as being invalid when executing

the S-0-0127, C0100 Communication phase 3 transition check

command.

1 2 ... 588 589 590 591 592 593 594 595 596 597 598 ... 727 728

Comentários a estes Manuais

Sem comentários

Bosch PIN8 N1 Guia de Resolução de Problemas Página 593

Comentários a estes Manuais

Manuais e produtos relacionados com Fogões Bosch PIN8 N1