Bosch LTC 2604 Manual de Instruções descarregar pdf (Página 25)

IntuiKey Series | Instruction Manual | Allegiant Error Messages

Bosch Security Systems | 28 June 2004

4.3 Allegiant Error Messages

Error Name Description

Error 01 Invalid Camera Request The camera number entered from the keyboard does not exist. If

using the optional LTC 8059/00 Master Control Software or the

LTC 8850/00 Graphical User Interface Software, ensure that the

number exists in the Camera Identification table. Download the

table to be sure.

Error 02 Invalid Monitor Request The monitor number entered from the keyboard does not exist.

Error 03 Remote Device Locked The remote device requested cannot be controlled, because it is locked

by User# by a user with equal or higher priority. Check with the other users or

request that a higher priority user unlock the remote device.

Error 04 Monitor Locked by User# The monitor requested cannot be accessed, because it is locked by

a user with equal or higher priority. Check with the other users or

request that a higher priority user unlock the monitor.

Error 05 Remote Device Access Restricted Remote locked out by Remote Lock Out table.

Error 06 Monitor Access Restricted Monitor locked out by Monitor Lock Out table.

Error 10 Access Denied A function was requested for which the user priority is too low. Only a

Priority 2 user or a supervisor with Priority 1 may access this function.

Error 11 Access Denied A function was requested for which the user priority is too low. Only

a supervisor with Priority 1 may access this function.

Error 15 Invalid User Function The function number requested from the keyboard is invalid. Refer to

the User Function table for a listing of valid user function numbers.

Error 20 Acknowledge Denied The ACKNOWLEDGE button was pressed by a user without the

authority to acknowledge alarms.

Error 21 Incorrect Acknowledge In order to properly acknowledge an alarm event, the keyboard must

be switched to a monitor that is displaying the alarms.

Error 22 Acknowledge Disabled Alarms on this monitor cannot be acknowledged, because that

capability has been disabled by the system programmer.

Error 23 Camera Not in Alarm The camera displayed on the monitor is not an alarm video; only

alarm-generated video can be acknowledged.

Error 24 Keyboard Not Enabled This keyboard may not acknowledge alarm video on this

for Acknowledge monitor; it has been disabled by the system programmer.

Error 25 Alarm Switcher Running Alarm video may only be acknowledged if the alarm switcher is not

running; press HOLD to stop the switcher.

Error 50 SEQUENCE Not Available The user attempted to load a switcher sequence that does not exist.

This is a good way to determine, from the keyboard, which sequence

numbers are unused when desiring to add one. A request was made

to load an ABSOLUTE type sequence, without the keyboard being

on one of the monitors in that sequence. Because inadvertent

loading of monitors should be avoided, the user is required to switch

his keyboard to one of the monitors used by the sequence. The

PROGRAM mode may be used to review which monitors are used

in the sequence.

Error 52 SEQUENCE Request A request was made to load a RELATIVE type sequence on a monitor

number that is too high; the monitors used by the sequence would

extend past the highest monitor. Try switching to a lower monitor number

before loading the sequence.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 47 48

Comentários a estes Manuais

Sem comentários

Bosch LTC 2604 Manual de Instruções Página 25

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Bosch LTC 2604