Bosch 7000 Series Manual descarregar pdf (Página 15)

 Bosch Alarm Panel Interface Manual

Revision 1.4

6 Add an Alarm Panel Area in System Galaxy

The Alarm Panel Area should be added in the System Galaxy software. The programming must match

the Alarm Panel Area configuration. An alarm panel area consists of 1 or more points

After Panel, Areas and Points are added, System Galaxy can begin receiving status events from the

alarm panel. (Note the alarm panel connection The alarm panel events are displayed in the Alarm Panel

Event screen.

STEP 6: Add an Alarm Panel Area as follows: (SG main menu: Configure>Hardware>Alarms)

Part 1: open the Alarm Panel Areas Property screen (Configure>Hardware>Alarms>Alarm Panel Areas)

Part 2: pick the desired alarm panel name from the Select Alarm Panel droplist

Part 3: click the Add New button and set the following fields as needed:

 Name field: type a descriptive name (preferably that matches the panel)

 Area Number: enter the area number

that matches the area in the alarm panel (1-8)

 Show in Tree: the show in tree checkbox allows Alarm Panel Area Icon to display in the

System Galaxy Hardware Tree.

Part 4: click the Apply button to save changes

NOTE: The SG Hardware Tree may need to be refreshed to pick up the Area Icon. To refresh

the hardware tree, simply close the tree’s window pane by clicking the [x] button at the

top and reopen it from the SG View menu (select View>Hardware Tree).

NOTE: The Alarm Panel Area Icon will display under the specific Alarm Panel Icon to which it is

assigned. Expand the Alarm Panels Icon, and then expend the Alarm Panel Icon to see

the Alarm Panel Area Icon.

FIG 6: Alarm Panel Area Property screen (cropped)

Page 15 of 37

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 36 37

Sem comentários

Bosch 7000 Series Manual Página 15