Bosch DS7445i Guia do Utilizador Página 45
- Página / 54
- Índice
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
DS7240/DS7220 User's Guide Copyright 2002 Detection Systems, Inc. P/N: 49211C Page 45
PART II: KEYPAD USER’S GUIDE: DS7445i LED KEYPAD
5.33 Remote Arming with Telephone, Area 1
I can perform this function.
I cannot perform this function.
Description
This function controls the built-in telephone arming
feature for Area 1. When enabled, the panel answers
the phone on the programmed ring count.
Procedure
When the panel answers the phone:
• If the panel is All On, Perimeter Only or Partial
On, it sounds three beeps and starts the
handshake tone for remote programming.
• If the panel is Off, it sounds one short beep,
waits approximately 3 seconds, and then starts
one long beep. Press and hold the [5] key* for
two seconds immediately after the first short
arming beep and before the long beep begins.
• The panel will arm if it detects a [5] key press
from the telephone (All On with Delay, faulted
zones are force-armed). The panel sounds
three beeps (new-armed state) and then
hangs up.
* If arming from a cell phone, quickly press the [5] key
three times. If pressing and holding the [5] key for two
seconds from a house (landline) phone does not
produce a tone long enough to arm Area 1, retry by
quickly pressing the [5] key three times.
Remotely disarming the panel cannot be done
with a telephone.
This feature is not permitted for UL
applications.
5.34 Remote Program
I can perform this function.
I cannot perform this function.
Key Sequence: [#] + [4] + [3]
Description
Use this function to connect to your Security
Company’s remote PC computer for programming
alterations via the telephone line.
Only use this function when your Security
Company instructs you to.
Procedure
1. Make sure that the system is turned off (Armed
LED is off).
2. Enter a valid user PIN.
3. Enter [#] + [4] + [3].
The keypad emits a single beep, indicating that
the remote programming session has begun.
When the session is completed, the keypad
automatically exits this function.
- User’s Guide for the 1
- MY ALARM COMPANY IS: 2
- Contents 3
- Part I: Introduction 4
- 3.0 Keypad Overview 5
- 3.2 Keypad Tones 6
- 3.3 Keypad LED Functions 6
- 3.4 Function Key Sequences 7
- 3.5 System Events 7
- 3.8 Logging Out of the System 7
- Part II: Keypad User’s Guide 8
- 4.7 Set Partial On Zones 10
- 4.10 Force Arming the System 12
- 4.11 View Faulted Zones 13
- 4.12 Bypass Zones 13
- 4.13 Date and Time 14
- 4.14 Change PIN 14
- 4.15 Change Others’ PINs 15
- 4.17 Add a PIN 16
- 4.18 Delete a PIN 17
- 4.19 Renew One-Time PINs 17
- 4.20 Check System Troubles 18
- 4.21 View Alarm Memory 18
- 4.22 View System Trouble 19
- 4.23 View Zone Trouble 19
- 4.24 System Test 19
- 4.25 Walk Test 20
- 4.26 Reset the System 21
- 4.27 Turn Chime On/Off 21
- 4.28 Select Chime Tone 21
- 4.29 Select Chime Zones 22
- 4.30 Extend Auto-On Time 22
- 4.31 Change Skeds 22
- 4.32 Change Outputs 25
- 4.33 Remote Program 26
- 4.34 All Areas Off 26
- 4.35 All Areas On 26
- 4.36 Move to Area 27
- 4.37 Auto-Forward On Setup 27
- 4.38 Auto-Forward Off Setup 28
- 4.39 Auto-Forward On/Off 28
- 4.41 View Log 29
- 5.1 Silence Alarms 30
- 5.2 Keypad Adjust 30
- 5.3 Turn the System Off 30
- 5.4 Turn the System All On 31
- 5.7 Set Partial On Zones 32
- Flashing Armed LED 33
- 5.10 Force Arming the System 34
- 5.11 Bypass Zones 35
- 5.12 Date and Time 35
- I can perform this function 36
- 5.17 Delete a PIN 39
- 5.18 Renew One-Time PINs 39
- 5.19 Check System Troubles 40
- 5.20 View Alarm Memory 40
- 5.21 View System Trouble 40
- 5.22 View Zone Trouble 41
- 5.23 System Test 41
- 5.24 Walk Test 42
- 5.25 Reset the System 42
- 5.26 Turn Chime On/Off 42
- 5.29 Extend Auto On Time 44
- 5.30 All Areas On 44
- 5.31 All Areas Off 44
- 5.32 Auto Forward On/Off 44
- 5.34 Remote Program 45
- Part III: Reference Materials 46
- 7.0 Panel Event Descriptions 47
- 10.0 Maintenance and Service 52
- 11.0 Power Failure 52
- 12.0 How to Clean the Keypad 52
- 13.0 Glossary 53
- Detection Systems, Inc. 6/02 54
- P/N: 49211C Page 54 of 54 54
Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Bosch DS7445i
(175 páginas)
(44 páginas)
(8 páginas)
(64 páginas)© 2020, manymanuals-pt.com. Todos os direitos reservados. | 0.031 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais