Bosch AMAX panel 4000 EN Guia de Instalação descarregar pdf (Página 158)

Keypad Sounds

Sound Indicator Definition

One short beep A keypad button has been pressed.

One single one- second beep The requested operation is refused. Incorrect

operation signal.

Two short beeps The system accepted the code. The system executed

the requested function.

One short beep every minute Fault tone, unacknowledged system failure

One short beep every two seconds Exit time started.

Continued sound – Last 10s on exit time

– Keypad fault/tamper sound (fault/tamper to be

acknowledged)

– Keypad alarm sound

Continuous 0.5 second beep, stops

0.5 seconds

Entry delay time (until alarm ends or system is

disarmed).

Arming and Disarming the System

Arming the System

Notice!

When the number of incorrect code entries on the keypad reaches a specified number, the

keypad will automatically lock for 180 seconds and alarm is reported. If the keypad is idle for

1 minute, the system will automatically exit from any operational mode.

Arming in AWAY Mode

Arming the system in AWAY Mode is normally performed when you leave the premises and

require that all zones are activated in a ready state to detect an intrusion.

Keypad Arming

There are two methods to arm your system in AWAY Mode.

Method 1:

To arm the System in AWAY mode enter your code and press [#].

It beeps twice, the AWAY indicator flashes slow, and exit time starts.

After exit time, the AWAY indicator turns is lit.

Method 2:

To arm the System in AWAY mode press and hold [#] until it beeps twice.

The AWAY indicator flashes slow, and exit time starts. After exit time, the AWAY indicator is lit.

Please contact your installer to enable/disable this function.

10.2

10.2.1

158 en | Keypad Usage and Operations

AMAX panel 4000 / AMAX panel 4000

2013.07 | 03 | F.01U.267.112 Installation Guide Bosch Sicherheitsysteme GmbH

1 2 ... 153 154 155 156 157 158 159 160 161 162 163 ... 175 176

Sem comentários

Bosch AMAX panel 4000 EN Guia de Instalação Página 158