Bosch X40 Manual do Utilizador descarregar pdf (Página 117)

VideoJet X40 SN Appendix | en 117

Bosch Security Systems Installation and Operating Manual DOC | V4.0 | 2009.06

Assigning an IP Address

Before you can operate a VideoJet X40 SN in your network you must first assign it an IP

address that is valid for your network.

The following default address is preset at the factory: 192.168.0.1

1. Start a terminal program such as HyperTerminal.

2. Enter the user name service. The terminal program displays the main menu.

3. Enter command 1 to open the IP menu.

4. Enter 1 again. The terminal program displays the current IP address and prompts you to

enter a new IP address.

5. Enter the desired IP address and press Enter. The terminal program displays the new IP

address.

6. Use the displayed commands for any additional settings you require.

Reboot

Briefly interrupt the power supply to the VideoJet X40 SN for a reboot (disconnect the power

supply unit from the mains supply and switch on again after a few seconds).

Additional Parameters

You can use the terminal program to check other basic parameters and modify them where

necessary. Use the on-screen commands in the various submenus to do this.

NOTICE!

You must reboot to activate the new IP address, a new subnet mask or a gateway IP address.

1 2 ... 112 113 114 115 116 117 118 119 120 121 122 ... 129 130

Sem comentários

Bosch X40 Manual do Utilizador Página 117