Bosch Solution 16plus Especificações descarregar pdf (Página 9)

FAULT Indicator

The FAULT indicator is used to display that the system has detected a system fault. Refer to

Fault Analysis Mode on page 16 for additional information on system faults.

Every time a new system fault has been detected (eg. FAULT indicator flashing), the

codepad will begin to beep once every minute. Pressing the # button once will cancel the

once a minute beep and acknowledge the fault (eg. FAULT indicator on steady).

FAULT Indicator Definition

There Is A System Fault That Needs To Be Rectified

Off

The System Is Normal, There Are No Faults

Flashing

There Is A System Fault That Needs To Be Acknowledged

Table 5: FAULT Indicator

Audible Indications

In general, the audible indicators given out by the codepad buzzer are as follows:

Audible Indicator Definition

Once Short Beep

A Button Has Been Pressed On The Codepad, Or, End Of Exit

Time When Armed In STAY Mode 1 Or STAY Mode 2

Two Short Beeps

The System Has Accepted Your Code

Three Short Beeps

The Requested Function Has Been Executed

One Long Beep

Indicates the End Of Exit Time When Armed In AWAY

Mode, Or The Requested Operation Has Been Denied Or

Aborted

One Beep Every Second

Walk Test Mode Is Currently Active Or Warning Before

Automatic Arming Takes Place

One Short Beep Every

Minute

There Is A System Fault Waiting To Be Acknowledged

Table 6: Audible Indicators

!"#$%&"'()* Operators Manual 9

Electronics Design and Manufacturing Pty Limited ISSUE160.DOC

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 43 44

Sem comentários

Bosch Solution 16plus Especificações Página 9