Bosch SF8172V Especificações descarregar pdf (Página 68)

American Dynamics Illustra 625 PTZ, Illustra 600/610 Compact Series Cameras, Illustra 825 Fisheye

23-5

defaulting will require the camera to be removed from the NVR and added

again. This is due to these actions changing number of video channels and their

configuration.

• In order to allow the simultaneous fisheye, panoramic or Active Image views, the

camera will be recognized as an encoder when added into the NVR. It will show

up as either a 2 (fisheye + panoramic) or 5 (fisheye + active image) channel

encoder depending on the stream configuration on the camera.

• The camera supports dual stream on active stream only - the secondary stream

is limited to a single stream of MJPEG 7 fps at the same resolution as the main

stream - when dual streaming, it is necessary to always update both stream or

issues may arise.

• Due to a camera limitation it is impossible to enable motion detection on the

fisheye stream.

• Due to camera behavior, when CBR bit rate is set to lowest in range (16) the

camera will not stream video.

• Illustra 610 Compact MiniBullet

• Due to a bandwidth limitation it is advisable not to configure the camera to

MJPEG 30FPS 1080P. If this configuration is required it is advised to lower the

quality to 50.

•

Known Issues

• Generic Function: The handler will attempt to auto detect most features such as VPA/LENS

properties, PTZ/Focus/Iris/Audio/Dry-Contact capabilities.

• Illustra 625 PTZ and Illustra 825 Fisheye:

• It is recommended to reboot these cameras following a stream configuration –

this will prevent a possible power loss to the units to cause stream configuration

conflict.

• Illustra 825 Fisheye:

• Active Image stream only: when changing video stream to MJPEG while on

NVR - the handler will automatically map it to the secondary limited stream - in

order to utilize a high resolution/frame rate MJPEG stream for live view or

recording, user can enable 2nd stream on the NVR first before switching 1st

stream on the NVR to MJPEG. While on Dual stream the resolutions of both

streams will need to be kept the same.

• When adding the camera manually to NVR the stream configuration will map 1-5

while if using NVR auto discovery it will map 0-4 User can manually edit names

if necessary.

• When configuring i825 on NVR - When displaying via Device list in Victor - some

cameras may show duplicate names - refreshing the cameras names a few

times will correct this issue.

•

• Illustra 6x0 Compact MiniDome and MiniBullet:

• When corridor mode is configured on a camera streaming at a high resolution

the camera will stream at half of the configured FPS.

• Corridor mode support: the NVR “Rotate Image” is limited to 0 ~ 360 degree.

Therefore rotating -90 degree with the camera in corridor mode is equal to

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 174 175

Comentários a estes Manuais

Sem comentários

Bosch SF8172V Especificações Página 68

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Bosch SF8172V