Bosch SF8172V Especificações descarregar pdf (Página 140)

Panasonic Corp

34-7

Note

Please refer to Panasonic cameras release notes published on the Panasonic website for more

information about Panasonic cameras and limitations.

Known Issues

Model Known Issues

All

For the models that support both of H.264 and MPEG-4 codecs, they can't support

these codec simultaneously. The real currently supported codec needs to be

explicitly set at the camera.

If audio bit rate is modified while streaming live in victor client, live audio may

become corrupt; re-adding the camera to the live view pane will fix this issue.

If the camera supports PTZ then there will be no relative focus or iris supported

NW484, NW960, NW964,

NS950, NS954, NP304,

NF302, NP244, NF284,

NS202, NS202A

By default, the MPEG-4 capability is turned off programmatically. This will

effectively disabled the audio capability, since the Panasonic handler utilizes

MPEG-4 stream for audio streaming.

MJPEG frame rate can be reduced if customer manually enables the MPEG-4

capability directly through the camera's web interface.

NW502S, NP502

Max frame rate for dual streaming is 15fps for VGA and 10 fps for QVGA.

For single video stream, when the resolution is 1.3 mega pixels, the maximum

frame rate for H.264 is 30fps. When the resolution is 3 mega pixels, the maximum

frame rate for H.264 is 15fps

SF332, SF335, SF336,

SW352, SW355, SP302,

SP305, SP306, SF342,

SF346, SP102, SP105,

NP304, NF302, NP244,

NF284, SW559, ST162,

ST165

These cameras support two aspect ratios 4:3 & 16:9. MPEG-4 is not available

when 16:9 is selected

When either H.264 or MPEG-4 transmission is set to On, the maximum frame rate

for MJPEG is 5fps

NP304, NF302, NP244,

NF284

It is not recommended to use audio with these models, due to the camera

limitation on the number of RTSP session. Using audio might result in losing live

video. At very low frame-rate settings for MPEG-4, i.e. 1fps - 3 fps it has been

observed that the actual frame-rate is much lower, between 0.5 fps - 1.5 fps. It is

recommended to use higher frame-rate settings in these models.

SC384, SC385, SW395,

SC386, SW396

In order to enable all four patterns, user needs to change the pattern setup by

camera web GUI, otherwise only part of the patterns can be used.

NP244, NF284, NS202A,

NW484, NS954, NW964,

NF302, NP304

In MPEG-4 mode, while streaming at more than 2048 Kbps these camera models

only support 1 effective stream in RTSP (Documented in "Function list of

camera_encoder.pdf" from Panasonic or Section 8.1 in "CGI Common Ref

Panasonic_Network_camera ver1.35.pdf"). Any access to camera web GUI while

using the camera in NVR might result in an error message "Too many concurrent

session" displayed on camera web GUI. This shall result in display of blue screen

instead of the actual video. Selection of MJPEG in camera web GUI should

restore the video. Because the audio stream is also attached with video stream,

the audio may be always inaccessible in this case.

1 2 ... 135 136 137 138 139 140 141 142 143 144 145 ... 174 175

Comentários a estes Manuais

Sem comentários

Bosch SF8172V Especificações Página 140

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Bosch SF8172V