Bosch SE2005 Guia de Configuração descarregar pdf (Página 39)

Security Escort | Installation and Setup Guide |4.0 System

Power-u

p

and Debu

g

EN | 39

Bosch Security Systems | 1/09 | 33831E

2. Select the desired transponder.

Click the Reset Transponder

Troubles button. If the selected

transponder is communicating with

the central console, the number “1”

appears in the Total Outgoing

Messages field and in the

Successful Incoming Messages field.

The transponder is now

communicating with the central

console software. If the number “1”

only appeared in the Total Outgoing

Messages field, there is a wiring

problem between the central console

and the transponder (refer to

Section

5.0 Testing and

Troubleshooting to locate the

problem).

3. Check the Stress Test box. This

tests the communications

reliability by causing the central

console software to send a

continuous stream of messages to

the selected transponder. The

values in the Successful Incoming

Messages and Total Outgoing

Messages fields should start

counting up rapidly, with few if

any errors. It is normal to have

slightly fewer Total Outgoing

Messages than Successful Incoming

Messages. If the errors are greater

than 1% of the number of messages,

then there is a problem that should

be corrected (refer to Section

5.0

Testing and Troubleshooting of

this manual to locate the problem).

4. Select the desired transponder.

After the Stress Test runs, any

current troubles are displayed in

the box in the transponder status

screen. Correct any troubles at

this time.

5. When the transponder is

communicating with all the

receivers and the Receivers

Database records are correct, back

up the database files to the hard

drive, if any changes were made.

Select Utilities Menu → Backup,

and make sure it is pointed to the

hard drive. Click Backup. It is

also wise to back up each database

to a 8.9 cm (3.5 in.) floppy. Label

the floppy with the databases and

backup date.

6. To confirm the RF reception, LED

and sounder operation, and location

of each receiver, select Setup →

Receiver. The screen shown in

Figure 19 appears:

Figure 19: Receiver Configuration

Screen

7. Select the desired transponder.

a. Click the ?

button next to the

point number. A bus and point

grid appears showing the

programmed receivers.

b. Click the lowest point number

button. If the first receiver is

point zero (0), click the Zero

button. If the first receiver is

point one (1), click the 1

button. The point number is

automatically entered.

c. Click the Put this receiver in

setup mode button. The red and

green LEDs light for the

selected receiver on the

selected transponder.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 53 54

Comentários a estes Manuais

Sem comentários