SC9000
ST150 SAFECOM Central Station Operations Manual
© 2002 Radionics Page 21 4998122249B
•
VAccount - 0001 to FFFF: The Virtual Account Number is used to specify the Subscriber Account number for
reporting SC2104 messages to the Automation software. The Virtual Account Number allows the SC2104 to appear
as any Subscriber Account in the Automation software. This feature is usually used to accommodate older accounts
that have been recently sold radio monitoring. By utilizing VAccount, there is no need to build a new customer
account in you Central Station automation system. The SAFECOM system can emulate your existing digital receiver.
If the Virtual Account is set to 0000, the SC2104 messages will be reported to the Automation software using the
SAFECOM Radio Communicator number.
•
Vline and VAccount apply to a full ST1000 system using an external automation software package. They are not
utilized in the ST150 software system.
•
Notes: The Notes area is used to enter four (4) lines, 35 characters each line, of plain language text. The Notes area
is usually used to identify important customer information such as name, address, phone number, etc.
SC2104 Radio Communicator Account Setup Menu #2
The parameters required to be programmed are shown in the illustration in bold type and described below:
•
Backpoll - Backpoll specifies the maximum amount of time a SC2104 will tolerate no radio communications with the
SC9000 computer.
•
Report Battery Trouble? - If this parameter is set to “Y” for Yes, then the SC2104 will report a low battery condition
to the Central Station if this condition occurs. If “N” for No, the SC2104 will ignore a low battery condition.
•
Report TELCO? - Y or N: If this parameter is set to “Y” for Yes, then the SC2104 will report “TELCO Trouble” to the
Central Station if the phone line backup is cut.. If “N” for No, the SC2104 will ignore a phone line cut condition.
•
Telco Trouble Delay - This defines the amount of time in seconds that an SC2104 will detect a phone line cut before
reporting it to the Central Station. This parameter is important, as a small delay (10 to 30 seconds) may be desired to
alleviate false reporting in areas with bad phone lines.
•
Telco Restore Delay - This defines the amount of time in seconds that an SC2104 will detect a phone line restore,
after cut, before reporting it to the Central Station. This parameter is important, as a small delay (10 to 30 seconds)
may be desired to alleviate false reporting in areas with bad phone lines.
•
Input Enabled? - Y or N: Entering Yes or No to this parameter will enable or disable the respective input. If an input
is programmed as N for No, the SC2104 will ignore any changes to this input.
•
1X, 2X, 3X, or 4X - Y or N: All of these specify whether the respective Input will be treated as an expanded or a non-
expanded input. “YES” = The Input will be treated as an expanded Input. The Input can be used for expanded
monitoring of two (2) Loops through a 1.1 K
Ω
resistor and a 2.2 K
Ω
resistor. The 1.1 K
Ω
resistor is the primary loop
for the input specified, the 2.2 K
Ω
resistor is the expanded loop for this input. “NO” = The Input will be treated as a
non-expanded Input. The Input will be used for non-expanded monitoring of one 3.3 K
Ω
resistor.
(140 páginas)
(12 páginas)
(24 páginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais