Bosch DS7447 Guia do Utilizador descarregar pdf (Página 39)

– 39 –

Testing Your System

Zone Test

The Zone Test is used to confirm that detectors will report alarms to the keypad. A Zone Test works on all zones, except 24-hour zones and

fire zones. While the keypad is in a Zone Test, no control panel alarms will activate an alarm, except 24-hour zone alarms and fire alarms;

these will override the Zone Test function.

This test requires you to manually alarm each zone.

At the start of the test, if so programmed, a report is sent to the central station followed by reports on the individual zones as they are tested.

Upon completion of the zone test, a test restoral report is sent to the central station.

If this test is performed from a Master keypad, it must be in Single Partition Mode. System Tests are not available from RF (wireless) keypads.

Note: It is recommended that the system be tested weekly.

* DS7447/DS7447E only

** DS7445/DS7445i only

Type of Test

Command

Sequence

What Will Happen What To Do

Zone Test [PIN] + [#] [8] [1]

•

“Test Zone” will display followed by the zone number

of any zones that have not been tested.*

•

The zone LEDs of any untested zones will flash.**

•

“Now Testing” will display followed by the zone

number of the zone that is currently being tested.*

•

The zone LED for the zone currently being tested

will turn on steady. **

•

As each zone is tested, the display turns to “Test

Zone” and indicates the remaining untested zones.*

•

As each zone is tested, its LED turns off.**

•

Test each zone a

instructed by you

installing company.

•

Exit the Zone Tes

using [PIN] + [#]

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 59 60

Sem comentários

Bosch DS7447 Guia do Utilizador Página 39