Bosch DS7445 Guia do Utilizador descarregar pdf (Página 16)

Page 16

Changing the Time

This chart will guide you through the steps necessary to change the Time displayed at the keypads.

You should write down your entries before you enter the Master Code Programming Mode and have them with you as you begin programming.

Make your entries promptly. If a long delay occurs in your entries, the 3-beep error tone sounds and exits you from the programming mode.

[Master Code] + [#] [0]

# 1. Enter the Master Code

Programming Mode.

"6 Change Time"

(display will scroll to this)

Steps to Change

the Time

If Accepted, DS7447 Display Reads

“Enter Day"

(1...7)

"Enter Time."

(0100...1259)

"Enter AM/PM.”

(4/6) End with #

“Day - Time”

A long beep signifies acceptance.

# 2. Enter a 6.

# 3. Enter the Day.

# 4. Enter the Time.

(Hour and minute)

# 5. Enter AM or PM.

[6]

[1]

through

[7]

Sunday Saturday

[0] [1] [0] [0]

through

[1] [2] [5] [9]

[4] [#] or [6] [#]

(4=AM, 6=PM)

Command

Sequence

NOTE:

Entering the command sequence [Master Code] [#] [0] [6] [#] will cause the DS7447 keypad to read back the time.

It is recommended that this procedure be performed at a DS7447 keypad.

No visual cues will be given from the DS7443S or DS7445 keypads.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 39 40

Sem comentários

Bosch DS7445 Guia do Utilizador Página 16