Bosch PXX875D34E Manual de Instruções Página 14

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 52
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 13
en Operating the appliance
14
Switching on the ventilation system
Note: If the
: and w symbols are not available, insert
the metal grease filter correctly.~ "Cleaning"
on page 39
The : and w symbols are available. The ventilation
system can be switched on.
1. Touch the : symbol.
The ventilation system starts at power level ƒ. The
power level that is set is displayed in the settings
area.
Notes
Heat settings cannot be changed while the
ventilation system power level is being set.
During a period of a few seconds, a power level
for the ventilation system can be selected. The
settings area can then be used for the heat
settings again.
2. Select the required power level from the settings
area.
The power level that is selected is displayed in the
settings area.
3. To set a different power level, touch the : symbol
and select the required power level from the settings
area.
The power level that is selected is displayed in the
settings area.
Switching off the ventilation system
If you want to switch off the appliance, touch the
# symbol. If you only want to switch off the ventilation
system, proceed as follows:
1. Touch the : symbol.
2. Select the symbol in the settings area.
3. Touch the : symbol to switch to the setting area for
the hob.
Note: The run-on will start once the appliance has been
switched off (depending on the basic settings selected).
Intensive setting
Activate intensive mode if strong odours or large
amounts of steam are produced. In this mode, the
ventilation system briefly operates at maximum power. It
automatically switches back to a low setting after a
short time.
Switching on
1. Touch the : symbol.
2. Touch the á symbol.
The á symbol lights up brighter and the line above the
á symbol lights up. Intensive mode is now activated.
Note: After eight minutes, the appliance automatically
switches back to fan setting Š.
Note: After a few seconds, the settings area for the heat
settings will be displayed again.
Switching off
1. Touch the : symbol.
2. Slide your finger over the settings area until setting
or another setting is displayed.
Automatic start
Depending on the basic settings selected, the following
options will be available once you have selected the fan
setting for a cooking zone:
The ventilation system will not start.
The ventilation system will start at the fan setting
selected by the sensor.
The ventilation will start at a specified fan setting.
Select the option you want to use in the basic settings.
The basic settings also offer the option to adjust the
sensitivity of the sensor. ~ "Basic settings"
on page 36
Vista de página 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 51 52

Comentários a estes Manuais

Sem comentários