Bosch CS10 Especificações descarregar pdf (Página 5)

Maintain a firm grip with both hands on the

saw and position your body and arm to

allow you to resist KICKBACK forces.

KICKBACK forces can be controlled by the

operator, if proper precautions are taken.

When blade is binding, or when interrupting

a cut for any reason, release the trigger and

hold the saw motionless in the material until

the blade comes to a complete stop. Never

attempt to remove the saw from the work or

pull the saw backward while the blade is in

motion or KICKBACK may occur. Investigate

and take corrective action to eliminate the cause

of blade binding. Wet lumber, green lumber or

pressure treated lumber require special

attention during cuRing operation to prevent

KICKBACK Avoid curing nails. Inspect for and

remove all nai/s from lumber before cuRin#

When restarting a saw in a workpiece,

center the saw blade in the kerr and check

that saw teeth are not engaged into the

material. If saw blade is binding, it may walk up

or KICKBACK from the workpiece as the saw is

restarted.

Support large panels to minimize the risk of

blade pinching and KICKBACK. Large panels

tend to sag under their own weight. Supports

must be placed under the panel on both sides,

near the line of cut and near the edge of the

panel. See "Cutting large Sheets" in this

manual

Do not use dull or damaged blade.

Unsharpened or improperly set blades produce

narrow kerr causing excessive friction, blade

binding and KICKBACK.

Blade depth and bevel adjusting locking

knobs must be tight and secure before

making cut. If blade adjustment shifts while

cutting, it may cause binding and KICKBACK.

Using the saw with an excessive depth of cut

seRing increases loading on the unit and

susceptibility to Misting of the blade in the kenf.

/t also increases the surface area of the blade

available for pinching under conditions of keff

close down.

Use extra caution when making a "Pocket

Cut" into existing walls or other blind areas.

The protruding blade may cut objects that can

cause KICKBACK.

I__ Some dust created by

power sanding, sawing,

grinding, drilling, and other construction

activities contains chemicals known to

cause cancer, birth defects or other

reproductive harm. Some examples of

these chemicals are:

• Lead from lead-based paints,

• Crystalline silica from bricks and cement

and other masonry products, and

• Arsenic and chromium from chemically-

treated lumber.

Your risk from these exposures varies,

depending on how often you do this type of

work. To reduce your exposure to these

chemicals: work in a well ventilated area, and

work with approved safety equipment, such

as those dust masks that are specially

designed to filter out microscopic particles.

-5-

1 2 3 4 5 6 7 8 9 10 ... 39 40

Comentários a estes Manuais

Sem comentários