Bosch HTS 62 Manual do Utilizador descarregar pdf (Página 10)

10 en | Programming via microSD card / hard disk drive Configuration Manager

970.129b | V2 | 2014.05 User Manual Bosch Security Systems

4.2 Programming procedure via microSD card

/ hard disk drive

Step 1: open the BPA setting file of the Carephone

 In the menu File, select Open to open the corresponding

parameter file from the microSD card or from the hard disk

drive.

Based on the BPA setting file, the Configuration Manager

identifies and displays the Carephone type in the lower right

corner of the window. In this case, you cannot change the

setting Carephone type.

Step 2: program the parameters of the Carephone

Change the parameters for the Carephone. Refer to

Section 6 Programming steps, page 16.

Step 3: save the parameters to the microSD card or hard disk

drive

 When you are finished programming, select Save to save

the BPA setting file to the microSD card or to the hard disk

drive. The file name must always be settings.bpa. If you

change the name of the file, then the upload of the

parameter update into the Carephone will malfunction.

NOTICE!

Before reading from the microSD memory card, make sure that

it contains a file. Before writing to the microSD memory card,

make sure that it is not write-protected. Existing files with same

names will be overwritten.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 35 36

Sem comentários

Bosch HTS 62 Manual do Utilizador Página 10