Bosch LTC 9441 Series Manual de Instruções descarregar pdf (Página 9)

4.5 Tilt Stop Adjustment (All Models)

After the unit is installed and all wire connections are made, apply

proper power to the control unit. Refer to

Figure 5, and adjust the

tilt stops as follows:

1. With the front of the pan/tilt facing you, remove the left hub

cap. The tilt stop adjustment screws are now exposed.

2. Using the control unit, tilt the bracket up to the desired posi-

tion and stop the unit. Use the 3/32-inch Allen wrench to

loosen the Tilt Up stop. Slide the stop Up until a faint click is

heard (indicating switch actuation). Tighten the Tilt Up limit

stop screw.

3. Using the control unit, tilt the bracket to the desired position

and stop the unit. Use the 3/32-inch Allen wrench to loosen

the Tilt Down stop. Slide the stop Down until a faint click is

heard. Tighten the Tilt Down limit stop screw.

4. Operate the control unit to verify proper tilt stop range and

operation. Repeat above sequence if necessary. Make certain

both tilt stop screws are snug. Replace the hub cap.

Figure 5: Tilt Stops (Side View - Plug Removed)

4.6 Pre-Position Models

The 345° models with pre-position capability require wiring

connections to pins 1 through 4, 8 and 9, and use of a controller or

receiver/driver with the pre-position function. Pan and tilt operation

and limit stop adjustments function the same as the previous models

described.

Tilt Up (CCW) StopTilt Down (CW) Stop

FRONTREAR

CAUTION: DO NOT OPERATE PAN/TILT UNIT WITHOUT

STOPS. LIMIT STOPS SHOULD NOT BE ADJUSTED

WHILE UNIT IS OPERATING.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Sem comentários

Bosch LTC 9441 Series Manual de Instruções Página 9