Bosch B450 Especificações descarregar pdf (Página 13)

1. Place the magnetic antenna on top of the enclosure, or vertically on another metal

surface.

Notice!

If you are experiencing a weak signal, place the antenna on top of a metal surface that has a

radius of 10.16 cm (4 in) for optimal performance.

2. Route the antenna cable through a knock-out in the enclosure wall.

3. Connect the antenna cable to the module.

4. Secure the antenna cable to the inside of the enclosure.

Figure 4.4: Antenna installation

Callout ᅳ Description

1 ᅳ B44x plug-in cellular communicator antenna (routed through any knock-out)

2 ᅳB44x plug-in cellular communicator antenna cable (connected to the module)

Wire to the control panel

When you wire a B450 to an SDI, or SDI2 control panel, you can use either the module's

terminal strip labeled R, Y, G, B (PWR, A, B, COM) or the module's interconnect wiring

connectors (wire included). The figure below indicates the location of both the terminal strip

and the interconnect wiring connectors on the module.

4.5

Conettix Plug-in Communicator

Interface

Installation | en 13

Bosch Security Systems, Inc. Installation and Operation Guide 2013.09 | 02 | F.01U.282.875

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 47 48

Sem comentários

Bosch B450 Especificações Página 13