Bosch Remote Control Manual de Instalação Página 1

SAR8854Rev. 07/08Installation Manual Bosch Eco26+External Model BC2600RAService Department: 1300 30 70 37www.bosch.com.auTo be installed and serviced

10Installation Instructions8. Water PipingThis appliance is suitable for potable water applications. Do not use this appliance if any part has been un

11Installation InstructionsSupply water piping• Do not use PVC, iron, or any piping which hasbeen treated with chromates, boiler seal or otherchemical

12Installation InstructionsPLEASE FOLLOW LOCAL CODES ABOUT CONDENSATE PIPING.• This water heater is a high efficiency, fully condensing appliance whic

13Installation InstructionsDo not connect electrical power to the unit until all electrical wiring has been completed.Consult a qualified electricianf

14Installation InstructionsThe remote controller will indicate when the neutralizer unit is in need of replacement by displaying an error code.Theref

15Installation InstructionsRemote controller cord• Use remote controller cord for any extensions.• Install according to the National Electrical Code a

16Installation Instructions(1) Open a hot water fixture and confirm that the Burner On lamp comes on, and that hot water isbeing produced. (If necessa

17Installation InstructionsLighting InstructionsThis water heater does not have a pilot. It is equipped with an ignition device that automatically li

18Installation Instructions13. Dimensions338(VIEW FROM TOP)27924313610060HOT WATER OUTLET (R3/4)1774858141179GAS INLET (R3/4)DRAIN OUTLET (R1/2)COLD W

2Installation InstructionsPotential dangers from accidents during installation and use are divided into the following threecategories. Closely observe

3Installation Instructions1. Included AccessoriesThe following accessories are included with the unit.Check for any missing items before starting inst

4Installation Instructions3. Before InstallationDo Not Use Equipment for Purposes Other Than Those Specified• Do not use for other than increasing the

5Installation Instructions4. Choosing Installation Site* Locate the appliance in an area where water leakage from the unit or connections will not res

6Installation Instructions5. Installation ClearancesBefore installing, check for the following:The location of the flue terminal must comply with the

7Installation InstructionsCLEARANCES FOR FLUE TERMINAL (front of heater)The location of the flue terminal must comply with the clearances shown on thi

8Installation InstructionsIllustration6. InstallationCheck4. Drill holes for the remaining four screws.5. Hang the unit again by the first screw, and

9Installation InstructionsGas Connection1) Fit a union to the water heater gas inlet for easy connec-tion and removal. The thread diameter is 20 mm.T