Bosch PFS 105 Especificações descarregar pdf (Página 10)

English | 17

Bosch Power Tools 1 619 929 K18 | (18.11.11)

Adjusting the Spray Pattern (see figure E)

f Never actuate the trigger switch 9 while adjusting the

air cap 3.

– Adjust the desired spray-jet width using adjusting lever 2.

– Turn the air cap 3 to the requested position.

Adjusting the Spraying Capacity (see figure F)

– To adjust the requested spraying capacity, turn the thum-

bwheel 7:

I: Min. spraying capacity,

IIII: Max. spraying capacity.

Adjusting the Air Flow (see figure G)

– Turn control knob 24 to adjust the air flow and the pres-

sure for the spray material being used.

It is recommended to start with the maximum air flow.

Work Breaks and Transport (see figure H)

During work breaks, the spray gun 1 can be placed into the

set-down port 25. The holding device ensures that the spray

gun is tightly seated in the set-down port. Spray material can-

not run out or escape.

– Place down the spray gun on the set-down port and push in

against the resistance until tightly seated.

The base unit comprises a carrying handle for easy transport

of the fine-spray system.

– Completely empty the container 10.

Make sure that the spray gun 1 contains no more paint:

Spray the spray gun empty.

– Place down the spray gun on the set-down port and push in

against the resistance until tightly seated.

Application Adjusting lever 2 Air cap 3 Spray jet pattern

Initial coatings, corners, edges

and hard to reach locations

Vertical compact jet for hori-

zontal coating direction

Horizontal compact jet for

vertical coating direction

Large-surface top coatings

Vertical wide jet for horizon-

tal coating direction

Horizontal wide jet for verti-

cal coating direction

Spraying capacity Adjustment

Too much material on target

area:

The spraying capacity must

be reduced.

– Turn the thumbwheel 7 in

direction I.

Not enough material on target

area:

The spraying capacity must

be increased.

– Turn the thumbwheel 7 in

direction IIII.

Minimal air flow Maximum air

flow

Air Flow Adjustment

Too much fog of coating

material:

The air flow must be re-

duced.

– Turn control knob 24 to-

ward the left.

Atomisation too coarse: The air flow must be in-

creased.

– Turn control knob 24 to-

ward the right.

OBJ_BUCH-1543-001.book Page 17 Friday, November 18, 2011 9:16 AM

1 2 ... 5 6 7 8 9 10 11 12

Comentários a estes Manuais

Sem comentários

Bosch PFS 105 Especificações Página 10

Comentários a estes Manuais

Manuais e produtos relacionados com Ferramentas elétricas Bosch PFS 105