Bosch MX30E Especificações descarregar pdf (Página 11)

-11-

NOTE: Speed is affected by voltages

changes. A reduced incoming voltage will

slow the OPM of the tool, especially at the

lowest setting. If your tool appears to be

running slowly, increase the speed setting

ccordingly. The tool may not start at the

lowest switch setting in areas where outlet

voltage is less than 120 volts. Simply move

the speed setting to a higher position to

begin operation.

The variable speed control settings are

marked on the speed control dial. The

settings for approximate /min (OPM) are:

Switch Setting Speed Range

/min (OPM)

1 8,000

2 10,400

3 12,800

4 15,200

5 17,600

6 20,000

You can refer to the charts on next page to

determine the proper speed, based on the

material and accessory being used. These

charts enable you to select both the correct

accessory and the optimum speed at a glance.

DM 2610033449 02-14_MX30E 2/11/14 12:54 PM Page 11

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 55 56

Sem comentários

Bosch MX30E Especificações Página 11