Bosch D9210C Manual do Proprietário descarregar pdf (Página 13)

Part I: Security System Basics

Fire Alarms

D1260 Owner’s Manual

Fire Alarms

Fire alarms are the highest priority events. When a fire point activates, your command center emits a pulsating high-

pitched fire tone. Evacuate all occupants and investigate for smoke or fire. Ensure that all occupants know the difference

between the burglary tone and the fire tone. The tone sounds for the time set by your security company.

Silencing Fire Alarms

Entering a personal passcode with the proper authority level silences a fire

alarm and disarms the system if it was armed.

The system will now display *Alarm Silenced* on the second line and

Clear Display> appears on the fourth.

Then the number of points in alarm (# FIRE

ALARMS) and then the area text appears (AREA 1

NAME TEXT) followed by the custom text of all the

points in alarm (SMOKE DETECTOR), in the order

of occurrence.

If there is more than one point causing an alarm, the

display will show each point for three seconds before

showing the next one.

When the last alarm is shown, the next display is the

idle text. The cycle is repeated until COMMAND 4 is

pressed.

Your system may be programmed so that you cannot

silence some fire alarms until the fire event clears.

Entering COMMAND 4 clears the scrolling point text

from the display.

3 seconds

The *Alarm Silenced* message will continue to alternate with idle text as

a reminder that it is still possible to view the text of the points in alarm by

using the View Memory function. See VIEW MEMORY ? (Command

40) for more information.

To clear the event memory and remove the *Alarm Silenced* message from the display, press the Clear Display>

soft key.

The display will show the instructions for clearing the message. Enter a

valid passcode and press the Clear> soft key.

If a fire trouble still exists after acknowledging the alarm, the display shows Fire Trouble.

To remove this display, the fire point(s) must be returned to normal. If you wish to review cleared events, use

COMMAND 40.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 153 154

Sem comentários

Bosch D9210C Manual do Proprietário Página 13