Operating andinstallation instructions
10Prior to installationExhaust-air modeThe exhaust air is discharged upwardsthrough a ventilation shaft or directlythrough the outside wall into the o
11Prior to installation❑ Flat ducts must have an internal cross-section that equates to that of roundpipes.There should be no sharp bends.For operatin
12Prior to installationCirculating-air mode❑ With activated carbon filter if exhaust-airmode is not possible.The complete installation set can beobtai
13InstallationThis extractor hood is intended to bemounted onto the kitchen wall.1. Remove the grease filter (refer to Operating Instructions).2. Draw
14Installation 08. Insert the other 4 screws with washers.Before the 4 screws are tighteneddown, align the extractor hood properly.09. Connect up the
15353121121DHZ 5145
9000 432 192Printed in Germany 0209 Es.E-Mail: [email protected]: www.bosch-eshop.com
2mind.650mind.550Abb. 1ELECTROFig. 1GAZ
3Appliance descriptionOperating InstructionsOperating modesExhaust-air mode:❑ The extractor-hood fan extracts the kit-chen vapours and conveys them th
4Before using for the first time If you encounter a problemIf you have any questions or if a faultoccurs, please call Customer Service. (See list of Cu
5Safety instructions Do not use the appliance if damaged. The appliance may be connected to themains by a qualified technician only. The appliance i
6Filters and maintenanceGrease filters:Metal filters are used to trap the greasyelement of the vapours that developduring cooking.The filter mats are mad
73. Insert the grease filters (see removal andinstallation of the metal-mesh greasefilters).Removing the filter:The filters are removed in reverse sequenc
8Replacing the light bulbs1. Switch off the extractor hood and pullout the mains plug or switch off the electricity supply at the fuse box.2. Remove t
9Important informationInstallation Instructions:Additional information concerning gascookers:When installing gas hotplates, complywith the relevant n
Comentários a estes Manuais