Bosch MAN-REG-X-08 Manual de Instalação Página 1

INSTALLATION INSTRUCTIONS REG-X

101. MECHANICAL SPECIFICATIONS – REG X (See Section 6 - General Specifications, for more information) Front View Side View Bottom

112. INPUT POWER / VIDEO OUTPUT CONNECTIONS The camera incorporates an electrically isolated power board for safe and easy 12 to 24 VDC/VAC operation

123. MOUNTING SPECIFICATION Caution: Install with appropriate screws to suit mounting surface. Select a suitable location protected from accidental

13 The REG-X units have a horizontal field of view of about 6ft – 8ft (1.8m – 2.4m) at the specified capture range distance for the REG-X as shown on

14The maximum angle of the camera to the car is 40º in combination of both horizontal and vertical angles. This limits the amount of skew of the lette

15 Figure 5 - Maximum Horizontal Angle If the maximum range is exceeded the letters will become smaller and be more difficult to read. At the max r

164. CAMERA ADJUSTMENT Figure 6 - Adjustment Set Screws 1) Mount and secure the REG-X unit according to specification (see Section 3

175. TROU BLESHOOTING GUIDE PROBLEM POSSIBLE CAUSE LIKELY SOLUTION No Video 1. Power Supply Connection Voltage Rang

18 Horizontal Scan Lines, Rolling Up or Down Negative, scrambled, or faded image Ground Looping on video cable

19 Safety and Precaution “Prolonged direct viewing of the REG-X camera product at any distance does not pose a hazard to the retina or cornea.”

2 MAN-REG-X-08 IMPORTANT SAFETY INSTRUCTIONS1. Read these instructions. 2. Keep this in

206. GENERAL SPECIFICATIONS Power Consumption: 6.5W max Input Voltage: 12 – 24 VDC or 12 – 24 VAC Enclosure (housing): Robu

21Note:

22Note:

23Note:

Americas Bosch Security Systems, Inc. 850 Greenfield Road Lancaster, Pennsylvania 17601 USA Telephone+1 888-289-0096 Fax +1 585

3plug does not t into your outlet, consult an electrician for replacement of the obsolete outlet. 9. Protect the power cord from being walked on or

4 IMPORTANT For best results, please read this Instruction Booklet prior to installing the REG-X camera. WARNING ! CSA Certified / UL Listed CLASS

5NOTE: This equipment has been tested and found to comply with the limits for a digital device, pursuant to part 15 of the FCC rules. These limits are

6 INDEX – REG-X Camera Description………………………………………………...7 Unpacking………………………………………………...8 Parts List…………………………………………………..8 Items Required for Inst

7DESCRIPTION The REG-X license plate capture camera unit consists of one IR-sensitive monochrome camera and one integrated panel of Infrared LEDs.

8UNPACKING Care should be taken when unpacking the shipped unit. Check the parts list and confirm all items have been located. Inspect the equipment

9INITIAL PREPARATIONS • Determine the operating voltage at the installation site. The camera‘s Voltage Regulator Board accepts both 12-24VDC and VA